
Ethanol Passes Test in Unmodified Marine Diesel Engine in Singapore
Cubierto por 3 fuentesPublicado
A Singapore-based research team, comprising the Global Centre for Green Fuels (GCGF) and the Maritime Energy and Sustainable Development Centre of Excellence (MESD) at Nanyang Technological University (NTU Singapore), successfully tested ethanol blends in a conventional, unmodified marine diesel engine. The finding, presented as preliminary results on November 16, opens up a possible decarbonization pathway for the existing commercial fleet, although unresolved safety and commercial challenges remain.
Stability Issue and Biodiesel Solution
The researchers found that ethanol does not form a stable blend with conventional diesel on its own: in the tests, ethanol and diesel separated into two phases within 24 hours, even when ethanol accounted for just 1% of the blend. To address this, they incorporated palm methyl ester (PME) biodiesel as a co-solvent compatible with both components, which made it possible to achieve stable ternary blends. A 1:1 ratio of ethanol to biodiesel maintained a single-phase blend throughout the entire heating and cooling cycle tested.
Three Formulations Tested in Pilot Engine
Three formulations -E10B10D80, E20B20D60 and E30B30D40- were tested in a four-stroke marine diesel engine of harbor-craft size, with technical support from the Seatrium New Energy Laboratory at NTU's School of Mechanical and Aerospace Engineering. All three ran reliably throughout the pilot trials. The highest formulation, E30B30D40, replaces 60% of conventional diesel with renewable ethanol and biodiesel by volume, equivalent to 53% on an energy basis, according to Manifold Times. Estimated brake thermal efficiency held steady or improved slightly across all test points, with gains of up to 0.73 percentage points for the E30 blend, while maximum engine power dropped by up to 12.9% with that same blend, a result expected given ethanol's lower energy density compared to fossil diesel.
Emissions and Next Steps
In terms of emissions, all blends reduced carbon monoxide, with a decrease of up to 43% for the E30 blend. The E10 and E20 blends also reduced nitrogen oxides (NOx) at equivalent-power test points, while E30 results varied depending on engine load. According to Manifold Times, the life-cycle greenhouse gas emissions intensity of the E30B30D40 blend is estimated at between 64.91 and 67.90 gCO2eq/MJ, representing a reduction of between 28% and 31% compared with the 94 gCO2eq/MJ baseline for conventional fossil diesel. However, these blends are not yet considered drop-in fuels under current standards, as flashpoint and fuel-system requirements are still under evaluation. GCGF and NTU MESD plan further engine tests and durability assessments, with the complete final report expected in 2027.



